To Resume Speed
Press the RES + button and release. Then remove your foot from the accelerator pedal. The EVIC will display the last set speed.
NOTE: You can resume ACC from a minimum of 20 mph (32 km/h).
WARNING!
The Resume function should only be used if traffic
and road conditions permit. Resuming a set speed
that is too high or too low for prevailing traffic and
road conditions could cause the vehicle to accelerate
or decelerate too sharply for safe operation. Failure to
follow these warnings can result in a collision and
death or serious personal injury.
See also:
Vacation Storage
Anytime you store your vehicle, or keep it out of service
(i.e., vacation) for two weeks or more, run the air
conditioning system at idle for about five minutes in the
fresh air and high blower ...
Cooling System Pressure Cap
The cap must be fully tightened to prevent loss of engine coolant (antifreeze),
and to ensure that engine coolant (antifreeze) will return to the radiator from
the coolant reserve tank.
The cap s ...
Add Names To Your Uconnect™ Phonebook
NOTE: Adding names to the Uconnect™ Phonebook is
recommended when the vehicle is not in motion.
• Press the button to begin.
• After the “Ready” prompt and the following beep, say
“P ...


