Using HomeLink
To operate, press and release the programmed HomeLink button. Activation will now occur for the programmed device (i.e., garage door opener, gate operator, security system, entry door lock, home/office lighting, etc.,). The hand-held transmitter of the device may also be used at any time.
See also:
Removing ACC Sensor For Off-Roading
NOTE: When off-roading, it may be advisable to remove
the ACC sensor. The sensor is located behind the
front lower grille in the center of the vehicle. After
removing the lower fascia, you may r ...
Engine Block Heater — If Equipped
The engine block heater warms the engine, and permits quicker starts in cold
weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a
grounded, three-wire extension cord.
...
Installing The LATCH-Compatible Child Restraint System
We urge you to carefully follow the directions of the
manufacturer when installing your child restraint. Not all
child restraint systems will be installed as described here.
Again, carefully foll ...