Customer-Programmable Features (System Setup)
Personal Settings allows you to set and recall features when the transmission is in PARK. If the transmission is out of PARK or the vehicle begins moving, a warning message SETUP NOT AVAILABLE, is followed in three seconds by, VEHICLE NOT IN PARK.
Press and release the UP or DOWN button until Setup displays in the EVIC.
Use the UP or DOWN button to display one of the following choices.
See also:
Tire Inflation Pressures
The proper cold tire inflation pressure is listed on the
driver’s side “B” Pillar or rear edge of the driver’s side
door.
The pressure should be checked and adjusted, as well as
inspect ...
Lowering The Windshield And Removing Side Bars
1. Lower the fabric top or remove the hard top following the instructions in
this manual.
NOTE: To assist in properly reinstalling side bars, mark the original locations
prior to removing.
2. Re ...
Recreational Towing — Four-Wheel Drive Models
The transfer case must be shifted into NEUTRAL (N) and
the transmission must be placed in PARK for recreational
towing. The NEUTRAL (N) selection button is adjacent to
the transfer case selector ...


