Using The Remote Control

1. Press the MODE button on the Remote Control.

2. While looking at Screen 1, highlight DISC by either pressing Up/Down/Left/Right buttons or by repeatedly pressing the MODE button, then press ENTER.

Select DISC Mode On The VES Screen
Select DISC Mode On The VES Screen

NOTE:
• Channel/Screen 1 select mode information is shown on the left side of the screen.

• Channel/Screen 2 select mode information is shown on the right side of the screen.

    See also:

    Emergency Tow Hooks — If Equipped
    If your vehicle is equipped with tow hooks, they are mounted in the front and the rear. NOTE: For off-road recovery, it is recommended to use both of the front tow hooks to minimize the risk of d ...

    Selection Of Engine Coolant
    Use only the manufacturer’s recommended engine coolant (antifreeze). Refer to “Fluids, Lubricants, and Genuine Parts” in “Maintaining Your Vehicle” for further information. CAUTION! ...

    Fog Lights — If Equipped
    To activate the front fog lights, turn on the parking lights or the low beam headlights and pull out on the end of the multifunction lever. Front Fog Light Control NOTE: The front fog lights ...