Rating and Password Setup
The Rating and Password settings work together to control the types of DVDs that your family watches. Most DVD-Video discs have a rating (from 1 to 8) assigned to them where lower numbers are designated for all audiences and higher numbers are designated for more adult audiences.
When a DVD-Video disc is loaded, its rating is compared to the setting in the DVD player. If the rating of the disc is higher than the setting in the player, a Password screen is displayed. In order to watch the disc, the rear passenger must enter the correct password using the password entry method described below.
To play all discs without requiring a password, set the DVD player’s rating to Level 8. Setting the rating to Level 1 always requires the password to play any DVD disc.
Not all DVD discs encode a Rating, so it is still possible that discs designed for adult audiences can still play without requiring a password.
The default rating is Level 8 (play all discs without a password) and the default password is 0000.
DVD Password Entry
To set the password, activate the DVD Setup Menu and follow these additional instructions:
• Using the remote control Left and Right cursor buttons, select the Rating tab.
• Highlight Change Password , and then press the remote control’s ENTER button.
• Enter the current password. Select a digit, use the remote control Up and Down cursor buttons to set the value for the current digit, and then press the remote control’s Right cursor button to select the next digit.
Repeat this digit selection sequence for all four digits.
• After the four-digit password is entered, press the remote control’s ENTER button. If the password is correct, the set password screen is displayed.
• Using the remote control’s Up and Down cursor buttons to set the value for the current digit and the remote control’s Right cursor button to select digits, enter the new password.
• After the four-digit password is entered, press the remote control’s ENTER button to accept the change.
DVD Player Level Menu
To set the rating, activate the DVD Setup Menu and follow these additional instructions:
• Using the remote control’s Left and Right cursor buttons, select the Rating tab.
• Highlight Change Rating , and then press the remote control’s ENTER button.
• Enter the current password. Select a digit, use the remote control’s Up and Down cursor buttons to set the value for the current digit, and then press the remote control’s Right cursor button to select the next digit. Repeat this digit selection sequence for all four digits.
• After the four-digit password is entered, press the remote control’s ENTER button. If the password is correct, the Rating Level menu is displayed.
• Using the remote control’s Up and Down cursor buttons, select the new rating level, and then press the remote control’s ENTER button to accept the change.
See also:
ESC Activation/Malfunction Indicator Light And ESC Off Indicator Light
The “ESC Activation/Malfunction Indicator
Light” in the instrument cluster will come on
when the ignition switch is turned to the ON
position. It should turn off with the engine
running. ...
Supplemental Seat-Mounted Side Air Bags (SAB) — If Equipped
Supplemental Seat-Mounted Side Air Bags (SAB) may provide enhanced protection
to help protect an occupant during a side impact. The SAB is marked with an air
bag label sewn into the outboard side ...
Adding Washer Fluid
The windshield and rear window washers share the same
fluid reservoir. The fluid reservoir is located in the front
of the engine compartment. Be sure to check the fluid
level in the reservoir at ...