Engine Block Heater — If Equipped
The engine block heater warms the engine, and permits quicker starts in cold weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a grounded, three-wire extension cord.
The engine block heater cord is located:
• 3.6L Engine – coiled and strapped to the engine oil dipstick tube.
• 5.7L Engine – bundled and fastened to the injector harness.
The engine block heater must be plugged in at least one hour to have an adequate warming effect on the engine.
WARNING!
Remember to disconnect the engine block heater
cord before driving. Damage to the 110-115 Volt
electrical cord could cause electrocution.
See also:
Jeep Grand Cherokee review
The following is a true story: While trying to access the lower Latch anchors
in the 2011 Jeep Grand Cherokee, my favorite sunglasses fell off my head and
onto the ground; in the heat of my effort ...
Operating Instructions - Radio Mode
NOTE: The ignition switch must be in the ON or ACC
position to operate the radio.
Power Switch/Volume Control (Rotary)
Push the ON/VOLUME control knob to turn on the
radio. Press the ON/VOLUME c ...
Closing Sunroof — Express
Press the switch forward and release it within one-half
second and the sunroof will close automatically from any
position. The sunroof will close fully and stop automatically.
This is called “E ...