Rear Axle Fluid Level Check
The rear axle oil level needs to be between 1/8 in (3 mm) below the bottom of the fill hole and the bottom of the fill hole.
The rear axle fill and drain plugs should be tightened to 22 to 29 ft lbs (30 to 40 N·m) on axles with aluminum housings. The rear axle fill and drain plugs should be tightened to 22 to 52 ft lbs (30 to 70 N·m) on axles with cast iron housings.
CAUTION!
Do not over tighten the plugs as it could damage then
and cause them to leak.
See also:
Two-Wheel Drive Models
The manufacturer recommends towing your vehicle with
all four wheels OFF the ground using a flatbed.
If flatbed equipment is not available, and the transmission
is operable, the vehicle may be to ...
Call Continuation
Call continuation is the progression of a phone call on the Uconnect™ Phone after
the vehicle ignition key has been switched to OFF. Call continuation functionality
available on the vehicle can ...
Barge In - Overriding Prompts
The “Voice Command” button can be used when you wish to skip part of a prompt
and issue your voice command immediately. For example, if a prompt is asking “Would
you like to pair a phone, cl ...