Rear License Lamp

1. Use a screw driver to gently pry against the side of the snap tab to remove the license lamp lens.

2. Pull bulb from socket.

3. Replace bulb.

4. Reinstall lens.

    See also:

    Front Axle Fluid Level Check
    The front axle oil level needs to be between 1/8 in (3 mm) below the bottom of the fill hole and the bottom of the fill hole. The front axle fill and drain plugs should be tightened to 22 to 29 ...

    Electronic Volume Control
    The electronic volume control turns continuously (360 degrees) in either direction without stopping. Turning the ON/VOLUME control knob to the right increases the volume and to the left decreases ...

    “Clean Radar Sensor In Front Of Vehicle” Warning
    The ACC “Clean Radar Sensor In Front Of Vehicle” warning will display when conditions temporarily limit system performance. This most often occurs at times of poor visibility, such as in sno ...