Replacement Keys
NOTE: Only keys that are programmed to the vehicle electronics can be used to start and operate the vehicle.
Once a Sentry Key is programmed to a vehicle, it cannot be programmed to any other vehicle.
CAUTION!
Always remove the Sentry Keys from the vehicle and lock all doors when leaving the
vehicle unattended.
At the time of purchase, the original owner is provided with a four-digit Personal Identification Number (PIN).
Keep the PIN in a secure location. This number is required for authorized dealer replacement of keys. Duplication of keys may be performed at an authorized dealer or by following the customer key programming procedure. This procedure consists of programming a blank key to the vehicle electronics. A blank key is one that has never been programmed.
NOTE: When having the Sentry Key Immobilizer System serviced, bring all vehicle keys with you to an authorized dealer.
See also:
Electronic Range Select (ERS) Operation
The Electronic Range Select (ERS) shift control allows the driver to limit the
highest available gear when the shift lever is in the DRIVE position. For example,
if you shift the transmission into ...
Canadian/Gate Operator Programming
For programming transmitters in Canada/United States
that require the transmitter signals to “time-out” after
several seconds of transmission.
Canadian radio frequency laws require transmitte ...
Operating Instructions - Radio Mode
NOTE: The ignition switch must be in the ON or ACC
position to operate the radio.
Power Switch/Volume Control (Rotary)
Push the ON/VOLUME control knob to turn on the
radio. Press the ON/VOLUME c ...