Transmitter Battery Replacement
The recommended replacement battery is CR2032.
NOTE: Perchlorate Material – special handling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate
1. With the RKE transmitter buttons facing down, use a flat blade screwdriver to pry the two halves of the RKE transmitter apart. Use extreme care not to damage the seal or internal components.
Separating RKE Transmitter Halves
2. Remove and replace the battery. Avoid touching the new battery with your fingers. Skin oils may cause battery deterioration. If you touch a battery, clean it with rubbing alcohol.
3. To reassemble the RKE transmitter case, snap the two halves together.
See also:
List Or Browse Mode
During Play mode, pressing any of the buttons described below, will bring up
List mode. List mode enables scrolling through the list of menus and tracks on the
audio device.
• TUNE control knob ...
Display Fuel Saver — If Equipped
The “ECO” message is located in the Compass/
Temperature display; this message can be turned on or
off. To make your selection, press and release the SELECT
button until “ON” or “OFF ...
Sky Slider™ Full Length Open Roof — If Equipped
The Sky Slider™ is a full-length, soft-top, power roof that
opens front to rear or rear to front. ...