How To Disengage The Automatic Locking Mode
Unbuckle the combination lap/shoulder belt and allow it to retract completely to disengage the Automatic Locking Mode and activate the vehicle sensitive (emergency) locking mode.
WARNING!
• The belt and retractor assembly must be replaced if the seat belt assembly Automatic
Locking Retractor (ALR) feature or any other seat belt function is not working properly
when checked according to the procedures in the Service Manual.
• Failure to replace the belt and retractor assembly could increase the risk of injury in collisions.
See also:
Engine Block Heater — If Equipped
The engine block heater warms the engine, and permits
quicker starts in cold weather. Connect the cord to a
standard 110-115 Volt AC electrical outlet with a
grounded three-wire extension cord.
...
Electronic Volume Control
The electronic volume control turns continuously (360 degrees) in either direction
without stopping. Turning the ON/VOLUME control knob to the right increases the
volume and to the left decreases ...
After Driving Off-Road
Off-road operation puts more stress on your vehicle than
does most on-road driving. After going off-road, it is
always a good idea to check for damage. That way you
can get any problems taken ca ...