Installing The LATCH-Compatible Child Restraint System
We urge you to carefully follow the directions of the manufacturer when installing your child restraint. Not all child restraint systems will be installed as described here.
Again, carefully follow the installation instructions that were provided with the child restraint system.

The rear seat lower anchorages are round bars, located at the rear of the seat cushion where it meets the seatback, and are visible when you lean into the rear seat to install the child restraint. You will easily feel them if you run your finger along the intersection of the seatback and seat cushion surfaces.

Latch Anchorages (Two-Door Models)

Latch Anchorages (Four-Door Models)
In addition, there are tether strap anchorages behind each rear seating position located on the back of the seat.

Tether Strap Mounting (Two-Door Models)

Tether Strap Mounting (Four-Door Models)
Many, but not all, restraint systems will be equipped with separate straps on each side, with each having a hook or connector for attachment to the lower anchorage and a means for adjusting the tension of the strap. Forwardfacing toddler restraints and some rear-facing infant restraints will also be equipped with a tether strap having a hook for attachment to the tether strap anchorage, and a means for adjusting the tension of the strap.
You will first loosen the child seat adjusters on the lower straps and on the tether strap so that you can more easily attach the hooks or connectors to the vehicle anchorages.
Next, attach the lower hooks or connectors over the top of the anchorage bars, pushing aside the seat cover material. Then, locate the tether anchorage directly behind the seat where you are placing the child restraint and attach the tether strap to the anchorage, being careful to route the tether strap to provide the most direct path between the anchor and the child restraint. Finally, tighten all three straps as you push the child restraint rearward and downward into the seat, removing slack in the straps according to the child restraint manufacturer’s instructions.
WARNING!
Improper installation of a child restraint to the LATCH anchorages can lead to failure
of an infant or child restraint. The child could be badly injured or killed. Follow
the manufacturer’s directions exactly when installing an infant or child restraint.
See also:
Towing This Vehicle Behind Another Vehicle
NOTE: Vehicles equipped with Quadra-Lift™ must be
lowered to the “Park” (lowest) level, and have automatic
leveling disabled, before tying them down (from the
body) on a trailer or flatb ...
Power Door Locks
The power door lock switch is located on each front door
panel. Press the switch to lock or unlock the doors.
Power Door Lock Switch
If the lock knob is down when the door is closed, the door
...
Voice Training
For users experiencing difficulty with the system recognizing
their voice commands or numbers, the Uconnect™
Phone Voice Training feature may be used. To enter this
training mode, follow one o ...


