Uconnect™ Phone Button

The radio or steering wheel controls (if equipped) will contain the two control

The radio or steering wheel controls (if equipped) will contain the two control buttons (Uconnect™ Phone Voice Command button) that will enable button and Voice Command you to access the system. When you press the button you will hear the word Uconnect™ button) that will enable you to access the system. When you press the button you will hear the word Uconnect™ followed by a BEEP. The beep is your signal to give a command.

NOTE: The driver side upper windshield trim contains the microphone for the Uconnect™ Phone.

    See also:

    Setup
    To switch to system setup, you may say on of the following: • “Change to setup” • “Switch to system setup” • “Change to setup” • “Main menu setup” or • “Switch ...

    High/Low Beam Switch
    Push the multifunction lever away from you to switch the headlights to high beam. Pull the lever toward you to switch the headlights back to low beam. ...

    Parksense System Usage Precautions
    NOTE: • Ensure that the rear bumper is free of snow, ice, mud, dirt and debris to keep the ParkSense system operating properly. • Jackhammers, large trucks, and other vibrations could aff ...