Cancel Command

At any prompt, after the beep, you can say “Cancel” and you will be returned to the main menu. However, in a few instances the system will take you back to the previous menu.

    See also:

    To Set The Variance
    Start the engine and leave the transmission gear selector lever in the PARK position. Press and hold the RESET button on the steering wheel (for approximately ten seconds) until the current varian ...

    1999 Jeep Wrangler review
    One would never expect to need a four-wheel drive vehicle unless snow is flying. But, this case tested that theory. I needed to travel to Philly to attend to some family business when the heaven ...

    Using The Remote Control
    1. Press the MODE button on the Remote Control. 2. While looking at Screen 1, highlight DISC by either pressing Up/Down/Left/Right buttons or by repeatedly pressing the MODE button, then press EN ...