Call by Saying a Name

• Press the • After the “Ready” prompt and the following beep, say “Call”. button to begin.

• After the “Ready” prompt and the following beep, say “Call”.

• The system will prompt you to say the name of the person you want to call.

• After the “Ready” prompt and the following beep, say the name of the person you want to call. For example, you can say “John Doe”, where John Doe is a previously stored name entry in the Uconnect™ phonebook or downloaded phonebook. To learn how to store a name in the phonebook, refer to “Add Names to Your Uconnect™ Phonebook”, in the phonebook.

• The Uconnect™ system will confirm the name and then dial the corresponding phone number, which may appear in the display of certain radios.

    See also:

    1997 Jeep Wrangler review
    A two-inch layer of ice is covering Hades this morning. Must be, because a few years ago after driving a Jeep Wrangler and commenting that even Mother Teresa would find fault with this vehicle, Ch ...

    Before Climbing A Steep Hill
    As you approach a hill, consider its grade or steepness. Determine if it is too steep. Look to see what the traction is on the hill side trail. Is the trail straight up and down? What is on top an ...

    Ignition Off Operation
    For vehicles not equipped with the Electronic Vehicle Information Center (EVIC), the power sunroof switch will remain active for 45 seconds after the ignition switch is turned to the LOCK positi ...