Place/Retrieve a Call From Hold

To put a call on hold, press the button until you hear a single beep. This indicates that the call is on hold. To button until you hear a single beep. This indicates that the call is on hold. To bring the call back from hold, press and hold the Toggling Between Calls button until you hear a single beep.

    See also:

    1997 Jeep Wrangler review
    A two-inch layer of ice is covering Hades this morning. Must be, because a few years ago after driving a Jeep Wrangler and commenting that even Mother Teresa would find fault with this vehicle, Ch ...

    To Enter Remote Start Mode
    Press and release the REMOTE START button on the RKE transmitter twice within five seconds. The vehicle doors will lock, the parking lights will flash and the horn will chirp twice (if progra ...

    Delete Uconnect™ Phonebook Entry
    NOTE: Editing phonebook entries is recommended when the vehicle is not in motion. • Press the button to begin. • After the “Ready” prompt and the following beep, say “Phonebook Delete ...