Call Termination

To end a call in progress, momentarily press the be terminated and if there is a call on hold, it will become the new active call. button. Only the active call(s) will be terminated and if there is a call on hold, it will become the new active call.

If the active call is terminated by the phone far end, a call on hold may not become active automatically. This is cell phone-dependent. To bring the call back from hold, press and hold the until you hear a single beep. button until you hear a single beep.

    See also:

    On the Trail
    Jeep's "Trail Rated" badge, which signals a host of off-road capabilities, seems superfluous here. With locking front and rear axles, a disconnecting front stabilizer bar for additional ...

    Fluid Level Check
    Check the fluid level by removing the fill plug. The fluid level should be between the bottom of the fill hole and a point not more than 3/16 in (4.76 mm) below the bottom of the hole. Add fluid, ...

    Front Map/Reading Lights
    The front map/reading lights are mounted in the overhead console. Front Map/Reading Lights Each light can be turned on by pressing a switch on either side of the console. These buttons are bac ...