List Paired Mobile Phone Names

• Press the • After the “Ready” prompt and the following beep, say “Setup Phone Pairing”. button to begin.

• After the “Ready” prompt and the following beep, say “Setup Phone Pairing”.

• When prompted, say “List Phones”.

• The Uconnect™ Phone will play the phone names of all paired mobile phones in order from the highest to the lowest priority. To “Select” or “Delete” a paired phone being announced, press the and say “Select” or “Delete”. Also, see the next two sections for an alternate way button and say “Select” or “Delete”. Also, see the next two sections for an alternate way to “Select” or “Delete” a paired phone.

    See also:

    Blower Control
    Rotate this control to regulate the amount of air forced through the ventilation system in any mode. The blower speed increases as you move the control to the right from the “O” (OFF) ...

    Ignition Off Operation
    The power sunroof switches can be programmed to remain active for up to approximately ten minutes after the ignition switch has been turned OFF. Refer to “Electronic Vehicle Information Center ...

    Service ACC Warning
    If the system turns off, and the EVIC displays “ACC/ FCW Unavailable Service Radar Sensor”, it indicates there is an internal system fault. Although the vehicle is still drivable under norma ...