Lane Change Assist :: Lights :: Understanding The Features Of Your Vehicle :: Jeep Wrangler Owner's Manual :: Jeep Wrangler - JeepManuals.org

Lane Change Assist

Jeep Wrangler / Jeep Wrangler Owner's Manual / Understanding The Features Of Your Vehicle / Lights / Lane Change Assist

Tap the lever up or down once, without moving beyond the detent, and the turn signal (right or left) will flash three times then automatically turn off.

See also:

Operating Instructions - Uconnect™ Multimedia (Satellite) Mode
NOTE: The ignition switch must be in the ON/RUN or ACC position to operate the radio. SEEK Buttons Press and release the SEEK buttons to search for the next channel in Satellite mode. Press the ...

Oil Change Required
Your vehicle is equipped with an engine oil change indicator system. The “Oil Change Required” message will flash in the EVIC display for approximately 10 seconds after a single chime has so ...

Spare Tire Removal
Fit the jack handle extension over the drive nut located in the rear cargo area inside the vehicle. Use the lug wrench to rotate the nut counterclockwise until the spare is on the ground with en ...