To Resume Speed :: Electronic Speed Control — If Equipped :: Understanding The Features Of Your Vehicle :: Jeep Wrangler Owner's Manual :: Jeep Wrangler - JeepManuals.org

To Resume Speed

Jeep Wrangler / Jeep Wrangler Owner's Manual / Understanding The Features Of Your Vehicle / Electronic Speed Control — If Equipped / To Resume Speed

To resume a previously set speed, push the RES (+) button and release. Resume can be used at any speed above 20 mph (32 km/h).

See also:

To Exit Remote Start Mode And Drive The Vehicle
Before the end of the 15-minute cycle, press and release the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm (if equipped). Then, insert the key into ...

Add Names to Your Uconnect™ Phonebook
NOTE: Adding names to the Uconnect™ Phonebook is recommended when the vehicle is not in motion. • Press the button to begin. • After the “Ready” prompt and the following beep, say “Ph ...

Hill Descent Control (HDC) – If Equipped
HDC is only intended for low speed off-road driving. HDC maintains vehicle speed while descending hills in off-road driving conditions by applying the brakes when necessary. When enabled, HDC se ...