Dual Top — If Equipped

If your vehicle is equipped with a Dual Top, you must remove one of the tops from the vehicle. If the soft top is removed, the pivot brackets must also be removed from the sport bar. The soft top was installed at the factory for shipping purposes only. The soft top and the hard top are to be used independently. Removal is mandatory to prevent any possible wear and tear on the soft top. Your vehicle warranty will not cover damage resulting from both tops remaining on the vehicle at the same time for extended periods of time.

See also:

Materials Added To Fuel
All gasoline sold in the United States is required to contain effective detergent additives. Use of additional detergents or other additives are not needed under normal conditions and would result ...

Front Panel(s) Installation With Rear Hard Top Removed
1. Turn the left and right panels over and move the spacer block (located on the rear of the panel) upward 90 degrees. NOTE: The front panel(s) must be positioned properly to ensure sealing. Set ...

To Vary The Speed Setting
While ACC is set, you can increase the set speed by pressing and holding the RES + button. If the button is continually pressed, the set speed will continue to increase in 5 mph (8 km/h) increme ...