Front Panel(s) Installation :: Freedom Top™ Three-Piece Modular Hard Top — If Equipped :: Understanding The Features Of Your Vehicle :: Jeep Wrangler Owner's Manual :: Jeep Wrangler - JeepManuals.org

Front Panel(s) Installation

Jeep Wrangler / Jeep Wrangler Owner's Manual / Understanding The Features Of Your Vehicle / Freedom Top™ Three-Piece Modular Hard Top — If Equipped / Front Panel(s) Installation

NOTE: Set the panels on the windshield frame so that there is no overhang. Also, make sure that the panels are sitting flush with the body.

1. Install the right panel first, then the left panel.

2. Reinstall the panel(s) using the same steps for removal in reverse order.

See also:

Call Continuation
Call continuation is the progression of a phone call on the Uconnect™ Phone after the vehicle ignition key has been switched to OFF. Call continuation functionality available on the vehicle ca ...

Front Panel(s) Installation With Rear Hard Top Removed
1. Turn the left and right panels over and move the spacer block (located on the rear of the panel) upward 90 degrees. NOTE: The front panel(s) must be positioned properly to ensure sealing. Set ...

Shifting Procedures
4WD HI To 4WD LOW With the vehicle at speeds of 0 to 3 mph (0 to 5 km/h), the ignition switch in the ON position or the engine running, shift the transmission into NEUTRAL, and press the “4WD ...