ESN/SID Access
With the ignition switch in the ON/RUN or ACC position and the radio on, press the SETUP button and scroll using the TUNE/SCROLL control knob until Sirius ID is selected. Press the TUNE/SCROLL control knob and the Sirius ID number will display. The Sirius ID number display will time out in two minutes. Press any button on the radio to exit this screen.
See also:
Keyless Enter-N-Go
This feature allows the driver to operate
the ignition switch with the push
of a button, as long as the ENGINE
START/STOP button is installed and
the Remote Keyless Entry (RKE) transmitter
...
Installing The Soft Top
NOTE: The following procedures are for first time set up only. For future
soft top procedures, refer to “Soft Top” in this section.
1. Locate and remove the following items prior to hard top re ...
Fluid Level Check – Brake Master Cylinder
The fluid level of the master cylinder should be checked
when performing under the hood service, or immediately
if the brake system warning lamp indicates system
failure.
The brake master cylin ...