Clock Setting Procedure :: Operating Instructions — Radio Mode :: Media Center 130 (Sales Code RES) :: Understanding Your Instrument Panel :: Jeep Wrangler Owner's Manual :: Jeep Wrangler - JeepManuals.org

Clock Setting Procedure

Jeep Wrangler / Jeep Wrangler Owner's Manual / Understanding Your Instrument Panel / Media Center 130 (Sales Code RES) / Operating Instructions — Radio Mode / Clock Setting Procedure

1. Press and hold the TIME button until the hours blink.

2. Adjust the hours by turning the right side TUNE/ SCROLL control knob.

3. After adjusting the hours, press the right side TUNE/ SCROLL control knob to set the minutes. The minutes will begin to blink.

4. Adjust the minutes using the right side TUNE/ SCROLL control knob. Press the TUNE/SCROLL control knob to save time change.

5. To exit, press any button/knob, or wait five seconds.

See also:

To Enter Remote Start Mode
Press and release the REMOTE START button on the RKE transmitter twice within five seconds. The parking lights will flash and the horn will chirp twice (if programmed). Then, the engine will ...

E-85 Usage In Non-Flex Fuel Vehicles
Non-FFV vehicles are compatible with gasoline containing 10% ethanol (E10). Gasoline with higher ethanol content may void the vehicle’s warranty. If a Non-FFV vehicle is inadvertently fueled with ...

Tire Pressure Monitor System (TPMS)
The Tire Pressure Monitoring System (TPMS) will warn the driver of a low tire pressure based on the vehicle recommended cold placard pressure. The tire pressure will vary with temperature by about ...