Normal Starting
NOTE: Normal starting of either a cold or a warm engine is obtained without pumping or pressing the accelerator pedal.
Turn the ignition switch to the START position and release when the engine starts. If the engine fails to start within 10 seconds, turn the ignition switch to the LOCK position, wait 10 to 15 seconds, then repeat the “Normal Starting” procedure.
See also:
Driving Through Water
Although your vehicle is capable of driving through
water, there are a number of precautions that must be
considered before entering the water:
CAUTION!
When driving through water, do not excee ...
Adding Washer Fluid
On vehicles equipped with a Electronic Vehicle Information
Center (EVIC), the low washer fluid level will be
indicated. When the sensor detects a low fluid level, the
windshield will light on th ...
In The 50 United States And Washington, D.C.
If you believe that your vehicle has a defect that could cause a crash or cause
injury or death, you should immediately inform the National Highway Traffic Safety
Administration (NHTSA) in additio ...


