Tip Start Feature – Automatic Transmission Only

Turn the ignition switch to the START position and release it as soon as the starter engages. The starter motor will continue to run, but will automatically disengage itself when the engine is running. If the engine fails to start, the starter will disengage automatically in 10 seconds.

If this occurs, turn the ignition switch to the LOCK position, wait 10 to 15 seconds, then repeat the “Normal Starting” procedure.

    See also:

    Liftgate
    To open the liftgate, pull up (squeeze) on the handle and lift. Liftgate Release NOTE: Use the power door LOCK switch on either front door trim panel or the Remote Keyless Entry (RKE) transm ...

    Windshield Wiper Operation
    Rotate the end of the lever upward to the second detent past the intermittent settings for low-speed wiper operation. Rotate the end of the lever upward to the third detent past the intermittent ...

    Offset Driving
    ACC may not detect a vehicle in the same lane that is offset from your direct line of travel. There will not be sufficient distance to the vehicle ahead. The offset vehicle may move in and out o ...