Engine Block Heater — If Equipped

Jeep Wrangler / Jeep Wrangler Owner's Manual / Starting And Operating / Engine Block Heater — If Equipped

The engine block heater warms the engine, and permits quicker starts in cold weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a grounded, three-wire extension cord.

The engine block heater cord is found under the hood bundled in front of the battery tray.

The engine block heater must be plugged in at least one hour to have an adequate warming effect on the engine.

WARNING!
Remember to disconnect the engine block heater cord before driving. Damage to the 110-115 Volt AC electrical cord could cause electrocution.

    See also:

    Cleaning Plastic Instrument Cluster Lenses
    The lenses in front of the instruments in this vehicle are molded in clear plastic. When cleaning the lenses, care must be taken to avoid scratching the plastic. 1. Clean with a wet soft rag.Amil ...

    Axle Lock (Tru–Lok ) — Rubicon Models
    The AXLE LOCK switch is located on the instrument panel (to the left of the steering column). Axle Lock Switch This feature will only activate when the following conditions are met: • Key in ...

    Headlight Time Delay — If Equipped
    This feature is particularly useful when exiting your vehicle in an unlit area. It provides the safety of headlight illumination for about 90 seconds after turning the ignition switch to the LOC ...