Overdrive Operation
The automatic transmission includes an electronically controlled Overdrive (fifth
gear). The transmission will automatically shift into the Overdrive gear if the
following conditions are present:
• the shift lever is in the DRIVE position,
• vehicle speed is sufficiently high, and
• the driver is not heavily pressing the accelerator.
See also:
Rear Axle Fluid Level Check
The rear axle oil level needs to be between 1/8 in (3 mm)
below the bottom of the fill hole and the bottom of the fill
hole.
The rear axle fill and drain plugs should be tightened to
22 to 29 f ...
1999 Jeep Wrangler review
One would never expect to need a four-wheel drive vehicle unless snow is
flying. But, this case tested that theory.
I needed to travel to Philly to attend to some family business when the
heaven ...
To Set The Variance
Start the engine and leave the transmission gear selector lever in the PARK position.
Press and hold the RESET button on the steering wheel (for approximately ten seconds)
until the current varian ...


