Side Step Removal – If Equipped

NOTE: Prior to off-road usage, the side steps should be removed to prevent damage.

1. Remove the two nuts from the bodyside.

2. Remove one bolt from the underside of the vehicle.

2. Remove one bolt from the underside of the vehicle.

3. Remove the side step assembly

3. Remove the side step assembly

    See also:

    Headlamps with Wipers (Available with Auto Headlights Only)
    When on is selected, and the headlight switch is in the AUTO position, the headlights will turn on approximately 10 seconds after the wipers are turned on. If the headlights were turned on by this ...

    Operating Instructions - Uconnect™ Multimedia (Satellite) Mode
    NOTE: The ignition switch must be in the ON/RUN or ACC position to operate the radio. SEEK Buttons Press and release the SEEK buttons to search for the next channel in Satellite mode. Press the ...

    Cooling System
    To reduce potential for engine and transmission overheating, take the following actions: − City Driving When stopped for short periods of time, shift the transmission into NEUTRAL and incr ...