Electronic Speed Control – If Equipped :: Towing Tips :: Trailer Towing :: Starting And Operating :: Jeep Wrangler Owner's Manual :: Jeep Wrangler - JeepManuals.org

Electronic Speed Control – If Equipped

Jeep Wrangler / Jeep Wrangler Owner's Manual / Starting And Operating / Trailer Towing / Towing Tips / Electronic Speed Control – If Equipped

− Do not use in hilly terrain or with heavy loads.

− When using the speed control, if you experience speed drops greater than 10 mph (16 km/h), disengage until you can get back to cruising speed.

− Use speed control in flat terrain and with light loads to maximize fuel efficiency.

See also:

Activating Adaptive Cruise Control (ACC)
You can only activate ACC if the vehicle speed is above 20 mph (32 km/h). When the system is turned on and in the READY state, the Electronic Vehicle Information Center (EVIC) displays “Adapt ...

Points To Remember
NOTE: When the vehicle is stopped after a few miles/ kilometers of operation, you may observe vapor coming from the front of the engine compartment. This is normally a result of moisture from rain ...

Sand
Soft sand is very difficult to travel through with full tire pressure. When crossing soft, sandy spots in a trail, maintain your vehicle’s momentum and do not stop. The key to driving in soft sa ...