Fluid Level Check

Check the fluid level by removing the fill plug. The fluid level should be between the bottom of the fill hole and a point not more than 3/16 in (4.76 mm) below the bottom of the hole.

Add fluid, if necessary, to maintain the proper level.

    See also:

    Manual Compass Calibration
    If the compass appears erratic and the “CAL” indicator does not appear in the EVIC display, you must put the compass into the Calibration Mode manually as follows: 1. Start the engine. Leave ...

    Axle Lock (Tru–Lok ) — Rubicon Models
    The AXLE LOCK switch is located on the instrument panel (to the left of the steering column). Axle Lock Switch This feature will only activate when the following conditions are met: • Key in ...

    Add Names to Your Uconnect™ Phonebook
    NOTE: Adding names to the Uconnect™ Phonebook is recommended when the vehicle is not in motion. • Press the button to begin. • After the “Ready” prompt and the following beep, say “Ph ...