Fluid Level Check :: Transfer Case :: Maintenance Procedures :: Maintaining Your Vehicle :: Jeep Wrangler Owner's Manual :: Jeep Wrangler - JeepManuals.org

Fluid Level Check

Jeep Wrangler / Jeep Wrangler Owner's Manual / Maintaining Your Vehicle / Maintenance Procedures / Transfer Case / Fluid Level Check

The fluid level should be to the bottom edge of the fill hole (A) when the vehicle is in a level position.

Adding Fluid

See also:

How To Engage The Automatic Locking Mode
1. Buckle the combination lap and shoulder belt. 2. Grasp the shoulder portion and pull downward until the entire belt is extracted. 3. Allow the belt to retract. As the belt retracts, you will ...

Front Panel(s) Installation With Rear Hard Top Removed
1. Turn the left and right panels over and move the spacer block (located on the rear of the panel) upward 90 degrees. NOTE: The front panel(s) must be positioned properly to ensure sealing. Set ...

Enabling And Disabling Parksense
ParkSense can be enabled and disabled with a switch located in the switch bank of the instrument panel or through the Customer-Programmable Features section of the EVIC. The available choices ar ...