Adding Fluid
Jeep Wrangler / Jeep Wrangler Owner's Manual / Maintaining Your Vehicle / Maintenance Procedures / Transfer Case / Adding Fluid
Fluid should be added only at filler hole until fluid begins to run out of the hole.
See also:
Ignition Off Operation
The power sunroof switches remain active for up to
approximately ten minutes after the ignition switch has
been turned OFF. Opening either front door will cancel
this feature. The time is progra ...
Automatic Transmission
The “DRIVE” range can be selected when towing. However,
if frequent shifting occurs while in this range,
activate the TOW/HAUL feature. Refer to “Automatic
Transmission” in “Starting a ...
Fluid Level Check
The fluid level should be to the bottom edge of the fill
hole (1) when the vehicle is in a level position.
1 — Fill Plug
2 — Drain Plug ...