Headlamp
1. Open hood and support using prop rod.
2. Remove the front grille. Turn the retainers along the top 1/4 turn counterclockwise and remove.
3. Pull the bottom of the grille away starting at one side and working toward the other.
4. Turn both park and turn signal socket assemblies 1/4 turn counterclockwise and remove.
5. Remove the four screws holding the metal retaining ring.
6. Remove the lamp from the collar.
7. Grasp the bulb and turn 1/4 turn counterclockwise.
8. Pull the bulb from the housing.
9. Push connector locking tab to the unlock position.
10. Remove connector from bulb.
11. Push connector onto new bulb base, and push the connector locking tab to the lock position.
CAUTION!
Do not touch the new bulb with your fingers. Oil contamination will severely shorten
bulb life. If the bulb comes in contact with any oily surface, clean the bulb with
rubbing alcohol.
12. Reinstall bulb housing. Rotate the bulb 1/4 turn clockwise.
See also:
To Set The Variance
Start the engine and leave the transmission gear selector lever in the PARK position.
Press and hold the RESET button on the steering wheel (for approximately ten seconds)
until the current varian ...
SAFETY
The 2011 Grand Cherokee has been named a Top Safety Pick by the Insurance
Institute for Highway Safety. To earn this safety nod, a car must receive the
top score of Good in front-, side-impact, re ...
Engine Break-In Recommendations
A long break-in period is not required for the engine and
drivetrain (transmission and axle) in your vehicle.
Drive moderately during the first 300 miles (500 km).
After the initial 60 miles (100 ...


