Delete Uconnect™ Phone Paired Mobile Phones

• Press the • After the “Ready” prompt and the following beep, say button to begin.

• After the “Ready” prompt and the following beep, say “Setup Phone Pairing”.

• At the next prompt, say “Delete” and follow the prompts.

• You can also press the any time while the button at any time while the list is being played, and then choose the phone you wish to delete.

    See also:

    Parksense Display
    When the vehicle is in REVERSE, the warning display will turn ON indicating the system status. Park Assist ON Park Assist Off The system will indicate a detected obstacle by showing three s ...

    Loose Fuel Filler Cap Message
    If the vehicle diagnostic system determines that the fuel filler cap is loose, improperly installed, or damaged, a loose gascap indicator will display in the EVIC telltale display area. Refer ...

    Operating Instructions — Radio Mode
    NOTE: The ignition switch must be in the ON or ACC position to operate the radio. Power Switch/Volume Control (Rotary) Push the ON/VOLUME control knob to turn on the radio. Push the ON/VOLUME co ...