Turn Signals

Move the multifunction lever up or down and the arrows on each side of the instrument cluster flash to show proper operation of the front and rear turn signal lights.

Turn Signal Operation
Turn Signal Operation

NOTE:
• If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb. If an indicator fails to light when the lever is moved, it would suggest that the indicator bulb is defective.

• A tone will chime if the turn signals are left on for more than 1 mile (2 km).

    See also:

    2007 Jeep Compass review
    After producing only one car on one shift for years, Chrysler Group promised a trio of machines from its Belvidere plant this year to keep the workers and company treasurer happy. First up was t ...

    Replacing The Batteries
    The remote control requires two AAA batteries for operation. To replace the batteries: • Locate the battery compartment on the back of the remote, then slide the battery cover downward. • Rep ...

    Delete Uconnect™ Phonebook Entry
    NOTE: Editing phonebook entries is recommended when the vehicle is not in motion. • Press the button to begin. • After the “Ready” prompt and the following beep, say “Phonebook Delete ...