Battery Replacement
The recommended replacement battery is CR2032.
NOTE:
• Perchlorate Material — special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate • Do not touch the battery terminals that are on the back housing or the printed circuit board.
1. Remove the screw from the RKE transmitter case (if equipped).
2. With the RKE transmitter buttons facing down, use a flat blade tool to pry the two halves of the RKE transmitter case apart. Make sure not to damage the seal during removal.
Separating Case Halves
3. Remove and replace the battery. Avoid touching the new battery with your fingers. Skin oils may cause battery deterioration. If you touch a battery, clean it with rubbing alcohol.
4. To reassemble the RKE transmitter case, snap the two halves together.
5. Reinstall and tighten the screw until snug (if equipped).
See also:
Compass Variance
Compass Variance is the difference between Magnetic North and Geographic North.
To compensate for the differences, the variance should be set for the zone where
the vehicle is driven, per the zone ...
Automatic Transmission
The DRIVE range can be selected when towing. However,
if frequent shifting occurs while in this range, the
TOW/HAUL mode (if equipped), or a lower gear range,
should be selected.
NOTE: Using th ...
Controlling The iPod Or External USB Device Using Radio Buttons
To get into the iPod /USB/MP3 control mode and access a connected audio device,
either press the “AUX” button on the radio faceplate or press the VR button and
say USB or Switch to USB . Once ...