Flash-To-Pass
You can signal another vehicle with your headlights by lightly pulling the multifunction lever toward you. This will turn on the high beam headlights until the lever is released.
NOTE: If the multifunction lever is held in the flash-topass position for more than 15 seconds, the high beams will shut off. If this occurs, wait 30 seconds before activating the flash-to-pass function again.
See also:
Interior Lights
The overhead light will turn on when a door is opened. It may also be turned
on by rotating the control for the dimmer switch on the multifunction lever fully
upward.
The overhead light will auto ...
Commands
The Voice Command system understands two types of
commands. Universal commands are available at all
times. Local commands are available if the supported
radio mode is active. ...
To Resume Speed
To resume a previously set speed, push the RES (+) button and release. Resume
can be used at any speed above 20 mph (32 km/h). ...