Lap/Shoulder Belt Untwisting Procedure
Use the following procedure to untwist a twisted lap/ shoulder belt.
1. Position the latch plate as close as possible to the anchor point.
2. At about 6 to 12 in (15 to 30 cm) above the latch plate, grasp and twist the belt webbing 180 degrees to create a fold that begins immediately above the latch plate.
3. Slide the latch plate upward over the folded webbing.
The folded webbing must enter the slot at the top of the latch plate.
4. Continue to slide the latch plate up until it clears the folded webbing.
See also:
Fluid Leaks
Check area under vehicle after overnight parking for fuel, engine coolant, oil,
or other fluid leaks. Also, if gasoline fumes are detected or if fuel, power steering
fluid, or brake fluid leaks ar ...
Driving In Snow, Mud And Sand
In heavy snow, when pulling a load, or for additional
control at slower speeds, shift the transmission to a low
gear and shift the transfer case to 4WD LOW if necessary.
Refer to “Four-Wheel Dr ...
Lowering The Soft Top
1 — Header Bow
2 — 2–Bow
3 — 3–Bow
4 — Sail Panel
5 — Body Side Retainer
6 — Quarter Window
7 — Check Strap
8 — Front Retainer — Quarter Window
9 — Bottom Retainer †...


