Engine Break-In Recommendations
A long break-in period is not required for the engine and drivetrain (transmission and axle) in your vehicle.
Drive moderately during the first 300 miles (500 km).
After the initial 60 miles (100 km), speeds up to 50 or 55 mph (80 or 90 km/h) are desirable.
While cruising, brief full-throttle acceleration within the limits of local traffic laws contributes to a good break-in.
Wide-open throttle acceleration in low gear can be detrimental and should be avoided.
The engine oil installed in the engine at the factory is a high-quality energy conserving type lubricant. Oil changes should be consistent with anticipated climate conditions under which vehicle operations will occur. For the recommended viscosity and quality grades, refer to “Maintenance Procedures” in “Maintaining Your Vehicle”.
CAUTION!
Never use Non-Detergent Oil or Straight Mineral Oil
in the engine or damage may result.
NOTE: A new engine may consume some oil during its first few thousand miles (kilometers) of operation. This should be considered a normal part of the break-in and not interpreted as an indication of difficulty.
See also:
TIME Button (CD MODE)
Press this button to change the display from a large CD playing time display
to a small CD playing time display. ...
Snow
In heavy snow or for additional control and traction at slower speeds, shift
the transmission into a low gear and the transfer case into 4L (Low) if necessary.
Do not shift to a lower gear than ne ...
Gross Trailer Weight (GTW)
The GTW is the weight of the trailer plus the weight of all cargo, consumables
and equipment (permanent or temporary) loaded in or on the trailer in its loaded
and ready for operation condition.
...


