Seat Belts
Inspect the belt system periodically, checking for cuts, frays, and loose parts. Damaged parts must be replaced immediately. Do not disassemble or modify the system.
Front seat belt assemblies must be replaced after a collision. Rear seat belt assemblies must be replaced after a collision if they have been damaged (i.e., bent retractor, torn webbing, etc.). If there is any question regarding belt or retractor condition, replace the belt.
See also:
Normal Starting
NOTE: Normal starting of either a cold or a warm engine is obtained without
pumping or pressing the accelerator pedal.
Turn the ignition switch to the START position and release when the engine sta ...
Electronic Vehicle Information Center (EVIC) Displays
When the appropriate conditions exist, the EVIC displays
the following messages:
• Low Tire Pressure
• Spare Low Pressure
• Premium TPMS Graphic Display
• Key in Ignition
• Turn ...
Narrow Vehicles
Some narrow vehicles traveling near the outer edges of
the lane or edging into the lane are not detected until they
have moved fully into the lane. There will not be sufficient
distance to the v ...