Keyless Enter-N-Go Display — If Equipped
When the ENGINE START/STOP button is pressed to change ignition switch positions, the Keyless Enter-N-Go icon momentarily appears in the lower right corner of the EVIC display showing the new ignition switch position.
Refer to “Keyless Enter-N-Go” in “Starting And Operating” for more information.
NOTE: Under certain conditions, the display may be superseded by another display of higher priority. But when the ignition switch position is changed, the display always re-appears.
See also:
Rear Tail, Stop, Turn Signal, And Backup Lamps
1. Raise the liftgate.
2. Remove the two push-pins from the tail lamp housing.
3. Grasp the tail lamp and pull firmly rearward to
disengage the lamp from the aperture panel.
4. Twist socket c ...
Passenger’s Power Seat
Some models are equipped with a six-way power passenger
seat. The power seat switch is located on the
outboard side of the seat. The switch is used to control
the movement of the seat and seat c ...
Engine Block Heater — If Equipped
The engine block heater warms the engine, and permits quicker starts in cold
weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a
grounded, three-wire extension cord.
...