Headlamp
1. Open the hood.
2. Reach behind the headlamp housing to access the headlamp bulb lock ring.
3. Firmly grasp the lock ring and rotate it counterclockwise to unlock it.
4. Remove the bulb and connector assembly from the headlamp housing.
5. Disconnect the bulb from the electrical connector and then connect the replacement bulb.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with any oily surface, clean the
bulb with rubbing alcohol.
6. Install the bulb and connector assembly into the headlamp housing and rotate the lock ring clockwise to lock it in place.
7. Close the hood.
See also:
Toggling Between Calls
If two calls are in progress (one active and one on hold),
press the button until you hear a
single beep,
indicating that the active and hold status of the two calls
have switched. Only one c ...
Tire And Loading Information Placard Location
NOTE: The proper cold tire inflation pressure is listed
on the driver’s side B-Pillar or the rear edge of the
driver’s side door.
Tire Placard Location ...
Windshield Wiper Blades
Clean the rubber edges of the wiper blades and the windshield periodically with
a sponge or soft cloth and a mild non-abrasive cleaner. This will remove accumulations
of salt or road film.
Operat ...