Road Tire Installation
1. Mount the road tire on the axle.
2. Install the remaining lug nuts with the cone shaped end of the nut toward the wheel. Lightly tighten the lug nuts.
WARNING!
To avoid the risk of forcing the vehicle off the jack,
do not tighten the wheel nuts fully until the vehicle
has been lowered. Failure to follow this warning may
result in personal injury.
3. Lower the vehicle to the ground by turning the jack handle counterclockwise.
4. Finish tightening the lug nuts. Push down on the wrench while at the end of the handle for increased leverage. Tighten the lug nuts in a star pattern until each nut has been tightened twice. The correct tightness of each lug nut is 110 ft/lbs (150 N·m). If in doubt about the correct tightness, have them checked with a torque wrench by your authorized dealer or service station.
5. After 25 miles (40 km) check the lug nut torque with a torque wrench to ensure that all lug nuts are properly seated against the wheel.
See also:
Answer or Reject an Incoming Call - No Call Currently in Progress
When you receive a call on your mobile phone, the Uconnect™ Phone will interrupt
the vehicle audio system, if on, and will ask if you would like to answer the call.
Press the button to accept t ...
Compass Variance
Compass Variance is the difference between Magnetic North and Geographic North.
To compensate for the differences, the variance should be set for the zone where
the vehicle is driven, per the zone ...
Operating Instructions — Radio Mode
NOTE: The ignition switch must be in the ON/RUN or ACC position to operate
the radio. ...


