Rear License Lamp

1. Use a screw driver to gently pry against the side of the snap tab to remove the license lamp lens.

2. Pull bulb from socket.

3. Replace bulb.

4. Reinstall lens.

    See also:

    Axles and Transfer Cases
    The Jeep Wrangler is now available with more axle gear ratios, allowing customers to optimize fuel economy and/or vehicle capability. Wrangler is available with 3.21, 3.73 or 4.10 ratios depending ...

    Fluid Level Check
    Check the fluid level while the transmission is at normal operating temperature 180° F (82° C). This occurs after at least 15 miles (25 km) of driving. At normal operating temperature, the fluid ...

    High/Low Beam Switch
    Push the multifunction lever away from you to switch the headlights to high beam. Pull the multifunction lever toward you, to switch the headlights back to low beam. ...