Raising The Windshield And Replacing Side Bars
1. Raise the windshield.
2. Loosely attach the rear of the side bar to the sport bar.
Refer to Step 4 of “Lowering Windshield And Removing Side Bars” earlier in this section.

• Reattach the sport bar Velcro covering.
3. Attach the front of the side bar to the windshield frame.
• Install the top two hex bolts (13 mm) first, then the lower side hex bolt (13 mm). The lower side bolt will not align until the top two bolts are installed.

4. Tighten all side bar attachment bolts.
5. Install the lower windshield plates with the six black round-headed Torx head screws (using a #40 Torx head driver) on each side of the base of the windshield.

6. Reinstall the wiper arms.
See also:
Exterior
Over the past few years, Jeep has consistently designed vehicles in the vein
of its beloved Cherokee of the 1980s — the large Commander and small Patriot
both share that look. The Liberty once h ...
If Your Engine Overheats
In any of the following situations, you can reduce the
potential for overheating your engine by taking the
appropriate action.
• On the highways — slow down.
• In city traffic — while st ...
Summer Operation
The engine cooling system in air-conditioned vehicles must be protected with
a high-quality antifreeze coolant to provide proper corrosion protection and to
protect against engine overheating. A s ...


