To Set The Variance

Start the engine and leave the transmission gear selector lever in the PARK position. Press and hold the RESET button on the steering wheel (for approximately ten seconds) until the current variance zone number is displayed.

To change the zone, press and release the STEP button to increase the variance one step. Repeat as necessary until the desired variance is achieved.

NOTE: The factory default zone is 8. During programming, the zone value will wrap around from zone 15 to zone 1.

    See also:

    Tip Start Feature – Automatic Transmission Only
    Turn the ignition switch to the START position and release it as soon as the starter engages. The starter motor will continue to run, but will automatically disengage itself when the engine is run ...

    Disabling And Enabling HSA
    This feature can be turned on or turned off. To change the current setting, proceed as follows: For vehicles equipped with the Electronic Vehicle Information Center (EVIC), refer to “Hill Start ...

    Garage Door Opener — If Equipped
    HomeLink replaces up to three hand-held transmitters that operate devices such as garage door openers, motorized gates, lighting or home security systems. The HomeLink unit is powered by your ve ...