Preparations For Jacking

1. Park on a firm, level surface. Avoid ice or slippery areas.

WARNING!
Do not attempt to change a tire on the side of the vehicle close to moving traffic, pull far enough off the road to avoid being hit when operating the jack or changing the wheel.

2. Turn on the Hazard Warning flasher.

3. Set the parking brake.

4. Shift the automatic transmission into PARK, or a manual transmission into REVERSE.

5. Turn the ignition to LOCK.

6. Block both the front and rear of the wheel diagonally opposite of the jacking

6. Block both the front and rear of the wheel diagonally opposite of the jacking position. For example, if changing the right front tire, block the left rear wheel.

NOTE: Passengers should not remain in the vehicle when the vehicle is being jacked.

    See also:

    Select Another Mobile Phone
    This feature allows you to select and start using another phone paired with the Uconnect™ Phone. • Press the button to begin. • After the “Ready” prompt and the following beep, say “S ...

    Overdrive Operation
    The automatic transmission includes an electronically controlled Overdrive (fifth gear). The transmission will automatically shift into the Overdrive gear if the following conditions are present: ...

    Roof Luggage Rack — If Equipped
    NOTE: Roof rack and crossbars cannot be used on vehicles equipped with Skyslider . The load carried on the roof, when equipped with a luggage rack, must not exceed 150 lbs (68 kg), and it shoul ...