Replacement Keys

NOTE: Only keys that are programmed to the vehicle electronics can be used to start and operate the vehicle.

Once a Sentry Key is programmed to a vehicle, it cannot be programmed to any other vehicle.

CAUTION!
Always remove the Sentry Keys from the vehicle and lock all doors when leaving the vehicle unattended.

At the time of purchase, the original owner is provided with a four-digit Personal Identification Number (PIN).

Keep the PIN in a secure location. This number is required for authorized dealer replacement of keys. Duplication of keys may be performed at an authorized dealer or by following the customer key programming procedure. This procedure consists of programming a blank key to the vehicle electronics. A blank key is one that has never been programmed.

NOTE: When having the Sentry Key Immobilizer System serviced, bring all vehicle keys with you to an authorized dealer.

    See also:

    Lap/Shoulder Belt Operating Instructions
    1. Enter the vehicle and close the door. Sit back and adjust the seat. 2. The seat belt latch plate is above the back of the front seat and next to your arm in the rear seat. Grasp the latch plate ...

    Adding Washer Fluid
    The fluid reservoir for the windshield washers and the rear window washer (if equipped) is shared. The fluid reservoir is located in the engine compartment. Be sure to check the fluid level at reg ...

    Safety
    The 2011 Grand Cherokee is a 2010 Top Safety Pick from the Insurance Institute for Highway Safety. To earn the designation, it received Good overall scores in IIHS' frontal-offset crash test, side ...