Flash Lights With Lock
The feature will cause the turn signal lights to flash when the doors are locked or unlocked with the RKE transmitter.
This feature can be turned on or turned off. To change the current setting, proceed as follows:
• For vehicles equipped with the Electronic Vehicle Information Center (EVIC), refer to “Electronic Vehicle Information Center (EVIC)/Personal Settings (Customer-Programmable Features)” in “Understanding Your Instrument Panel” for further information.
• For vehicles not equipped with the EVIC, perform the following steps:
1. Press and hold the UNLOCK button on a programmed (i.e., functional) RKE transmitter for at least 4 seconds, but no longer than 10 seconds. Then, press and hold the LOCK button while still holding the UNLOCK button.
2. Release both buttons at the same time.
3. Test the feature from outside the vehicle by pressing the LOCK and UNLOCK buttons on the RKE transmitter.
4. Repeat these steps if you want to return this feature to its previous setting.
NOTE: Pressing the LOCK button on the RKE transmitter while you are inside the vehicle will activate the Security Alarm. Opening a door with the Security Alarm activated will cause the alarm to sound. Press the UNLOCK button to deactivate the Security Alarm.
See also:
RW/FF
Pressing the RW (Rewind) or FF (Fast Forward) buttons causes the tuner to search
for the next frequency in the direction of the arrows. This feature operates in
either AM or FM frequencies. ...
Memo
To switch to the voice recorder mode, say “Memo”. In
this mode, you may say the following commands:
• “New Memo” (to record a new memo) — During the
recording, you may press the Voic ...
Mist Feature
Push down on the wiper lever to activate a single wipe to clear off road mist
or spray from a passing vehicle. As long as the lever is held down, the wipers will
continue to operate.
NOTE: The mi ...